Quadra-Fire CASTILE-PMH Stove User Manual


 
Page 28
250-6422D
October 11, 2005
R
Castile Pellet Stove
R
R
6. Disposal of Ashes
Frequency: As needed
By:
Homeowner
Task:
Ashes should be placed in a metal container with a
tight-fitting lid. The closed container of ashes should
be placed on a noncombustible floor or on the ground,
well away from all combustible materials, pending final
disposal. If the ashes are disposed of by burial in soil
or otherwise locally dispersed, they should be retained
in the closed container until all cinders have been
thoroughly cooled.
7. Cleaning Heat Exchanger Chambers
Frequency: Weekly or as needed
By:
Homeowner
Task:
The amount of ash buildup in the firepot will be a good
guide to determine how often you should clean the heat
exchangers.
a. Allow the appliance to completely cool down before
pulling the cleaning rods. Turn the thermostat on and
then immediately off to start the exhaust blower on its
cycle time. It will pull fly ash out the exhaust instead
of into the room. Open the cast hinged face to access
the 2 cleaning rods. See Figure 28.1.
b. Locate the 2 rods directly underneath the heat
exchanger tubes. Rods are bent at a 90° angle for
easy handling.
3. To clean, pull the rods straight out until it stops,
approximately 5-1/2 inches (140mm). Slide the rods
OUT and IN a couple of times.
Figure 28.1
8. Cleaning Beneath Heat Exchanger
Frequency:
Monthly or after burning 1 ton of fuel
By: Homeowner
Task:
A more thorough cleaning is needed to remove the excess
ash that is left behind from the use of the cleaning rods
for the heat exchanger tubes. The ash will be resting on
the back of the baffle. This will require removing the cast
baffle. Please refer to page 32 for a detailed explanation
of removing the baffle.
WARNING
Heat exchanger cleaning rods may be warm
to the touch. For safety purposes wear
gloves.
Do not pull heat exchanger cleaning rods
while appliance is operating.
NOTE:
There are heavy duty vacuum cleaners specifically
designed for solid fuel appliance cleaning.
9. Cleaning the Glass
Frequency: As needed
By:
Homeowner
Task:
a. Appliance must be completely cool before cleaning
glass.
b. Use a damp paper towel or any non-abrasive glass
cleaner. Wipe off with dry towel.
Handle glass assembly with care.
When cleaning glass:
Avoid striking, scratching or
slamming glass.
Do NOT clean glass when hot.
CAUTION
Do NOT use abrasive cleaners.
Use a hard water deposit glass cleaner on white film.
Refer to maintenance instructions.
Handle glass with care.
Inspect the gasket to ensure it is
undamaged.
Do NOT strike, slam or scratch glass.
Do NOT operate appliance with glass
assembly removed.
WARNING
Do NOT operate with glass cracked, broken or
scratched.
Heat Exchanger Tubes
Cleaning Rods
Disposal of Ashes
WARNING
Ashes should be placed in metal container
with tight fitting lid.
Ashes should be retained in closed container
until all cinders have thoroughly cooled.