Filter
Top Products
R
R
R
October 11,, 2005
250-6422D
Page 19
Castile Pellet Stove
E. Optional Log Set Placement Instructions
4 PIECE LOG SET INSTALLATION
Figure 19.1
CAUTION
Logs are FRAGILE. Use extreme care when handling or
cleaning logs.
NOTE:
Due to the abrasive nature of a pellet appliance fire, the
logs are not covered under warranty. Any placement varia-
tion other than shown here can cause excessive heat and
shall void the appliance warranty.
1. Open the hinged cast face and open the glass door
assembly.
2. To position the logs, place the right rear log as shown in
Figure 19.1. There is a notch in the bottom of the log for
clearance for the thermocouple and thermocouple cover
(ceramic protection tube).
3. Continue placing the last 3 logs around the firepot as
show in Figures 19.2, 19.3 and 19.4
. Be careful not to
block the drop tube in the back of the firebox where pel-
lets feed into the firepot.
Place the log over the firepot. The
charred area on the back of the log is
turned toward the back, not the front.
The log will be about 2-1/2 inches
above the firepot when in place. It
must rest on the 3 logs in a stable
position to prevent it from falling into
the firepot.
OPTIONAL TOP LOG
Drop Tube
Notch
Thermocouple
Cover
Figure 19.2
Figure 19.3
Figure 19.4
Figure 19.5