Filter
Top Products
PWM-T210
Installation Instructions Page 9
Mounting the Display
WARNING: AT LEAST (2) QUALIFIED PERSONNEL ARE STRONGLY RECOMMENDED FOR
INSTALLATION OF THIS PRODUCT. FAILURE TO DO SO COULD RESULT IN
SERIOUS INJURY AND POSSIBLE DAMAGE TO THE FLAT PANEL.
1. Raise the flat panel with the mounting brackets secured to the flat panel and insert the top and bottom
hooks from each bracket to the rods from the wall plates (Figure 15).
Top
Bottom
Figure 15
2. Make any lateral shift adjustments and lock the display in place by tightening the two (2) M6 x 30 (mm)
Phillips screws found on the bottom of the mounting brackets (Figure 16).
CAUTION
: Do not over tighten the M6 screws to the rods.
Figure 16
Lateral Shift
M6 x 30 Lateral
Shift Screw
M6 x 30 Lateral
Shift Screw