Filter
Top Products
43. Undersized or overloaded service wiring.
Remedy: Call your electrical contractor.
44. Power surge.
Remedy: Call your electrical contractor.
45. Power short in unit.
Remedy: Locate short circuit and correct.
46. Pellets in hopper are giving off an odor.
Remedy: Change the brand of pellets you are using, some species of wood have unpleasant
odors.
47. Mounting bolts on the blower are loose.
Remedy: Tighten the mounting bolts.
48. Remote thermostat is not level.
Remedy: Level the thermostat using a water bulb.
49. Ash pan door or other heat exchanger cover plate not on tight.
Remedy: Tighten all nuts and check all gaskets.
50. Thermostat wires are shorting out.
Remedy: Remove thermostat from the base, if burner continues to run, go back to tie in at
primary control yellow leads, disconnect and separate, if burner stops, then
you have a short in the remote wires. Trace and correct or replace. Look for tacks or nails
through wires.
51. A bearing is failing on the blower motor.
Remedy: Replace the blower.
52. Fan limit control is stuck.
Remedy: Make sure that the white button is in the auto position, tap the fan limit control
lightly. If this does not shut of the blower then replace the fan limit control.
53. Bad pellets.
Remedy: Are you using approved pellets that meet the manufacturer's specifications? Use
of non approved pellets will impair the functioning of your stove and may void your
warranty.
54. That's the nature of the Honeywell T87F thermostat.
Remedy: Adjust thermostat to your comfort level not a numbered dial.
55. Normal draft inducer hum anytime the unit is plugged in.
Remedy: Install duro-dyne duct isolator.
56. Blower blades are dirty and full of lint and/or hair.
Remedy: Clean the blades.
57. Draft inducer blades are dirty and full of lint and/or hair.
Remedy: Clean the blades.
58. Furnace venting improperly installed.
Remedy: Check installation manual to verify correct install on unit.
25