Filter
Top Products
15
Chapter 2: Installation
BOARD LEVEL INSTALLATION (FGD-5100)
This section explains the unpacking and installation of a board level ISACC. For installation
instructions of a complete package ISACC (FGD-5000), turn to page 11. It is important that
this chapter be read and followed very carefully before operating ISACC.
UNPACKING ISACC
ISACC is shipped in specially designed packaging to eliminate damage during shipment.
When unpacking the unit, be careful not to damage the equipment or the box. It is recom-
mended that the packaging be retained for future use.
Within the packaging will be a Warranty Registration Card. Please take the time to fill this
out and mail. The Limited 1 Year Warranty is explained in the back of this manual.
CAUTION: ISACC is a sensitive electronic device. Personnel and work area should be
grounded before handling this device. Do not install ISACC near strong electrostatic, electro-
magnetic, magnetic or radioactive fields. Do not attach the power supply cord to building
surfaces.
GROUNDING WRIST STRAP
Enclosed with the product is a Disposable Grounding Wrist Strap. It is provided to help
control and prevent the possibility of damage due to static electricity.
To use the grounding strap, unwrap the strap to expose the adhesive. Wrap the adhesive
around your wrist. Unwrap the rest of the strap and peel the liner away from the copper foil,
located at the opposite end. Attach the copper foil to an earth-grounded object. NOTE: The
grounding wrist strap is for static control. It will not reduce or increase the risk of receiving
electrical shock.
OPERATING ENVIRONMENT
ISACC should be mounted and operated in a clean, dry environment. The recommended
temperature range that ISACC should operate in is 32°F to 120°F (0°C to 49°C).
MOUNTING ISACC
When you receive ISACC, there will be a PC Board (ISACC), an instruction manual, and a
Mounting Hardware Kit. Inside the Mounting Hardware Kit are the following:
• 4 Hollow Nylon Spacers
• 4 #8-32 1˘” Machine Screws
• 4 #8 ˚" Wood Screws
• 4 Nylon Washers
• 4 #8-32 Hex Nuts
Carefully remove ISACC from the bubble pack. Decide where you will be mounting ISACC
and drill holes according to the diagram on the next page. The circuit board dimensions are
8" by 11".