Filter
Top Products
• Remove the mounting screw, remove the control box cover,
and then connect the wires by following the procedure given
in the illustration.
2. Fitting the decorative panel
• Temporarily secure the fixing screws (3 pcs.) before fitting
the decorative panel. (For temporarily securing the front
grille.)
• Place decorative panel on the screws (3 pcs.) before fitting,
move decorative panel as illustrated and tighten all the
screws (4 pcs.).
CAUTION
• Check before hand the height from the ceiling to the
unit.
• The front grille fitting direction is determined by the unit
direction.
• Only use the screws with the length of 35mm which is
provided, to fix the decorative panel.
• Do not use other screw which is longer it may cause
damage to the drain-pan and other components.
Earth lead wire shall be longer than other wires as shown in
the figure for the electrical safety in case of the slipping out
of the cord from anchorage.
11.2.6. CONNECTING THE CABLE TO THE INDOOR
11.2.7. INSTALLATION OF DECORATIVE PANEL
The decorative panel has its installation direction. Confirm the direction by displaying the piping side.
1. Remove the air inlet grille by moving the catchers to center.
60
CS-E15DB4EW CU-E15DBE / CS-E18DB4EW CU-E18DBE / CS-E21DB4ES CU-E21DBE