Filter
Top Products
F. Fasten the door to opening
by driving 2” galvanized
roong nails into each
pre-punched hole in the
nailing n.
Note: Make sure the n
corner is lying as at as
possible.
Exterior
3H
3F
Interior
3K
3J
G. Carefully open the door(s) and remove all
shipping spacers.
Note: Be sure to remove the spacers from the
bottom edge of the door panel.
Double doors with center latch:
Designer Series Only: Use the construction
handle to operate the active door handle.
Operate the ushbolts per the instructions on
the label on the strike located on the astragal.
Architect Series Only: Use the construction handle to operate both the active and passive
door panels.
H.
For Designer Series Only: Install sill screws. Place a dab of sealant in each of the pre-
drilled holes in the bottom of the unit (sill). en insert a #8 x 2” corrosion resistant screw
(provided) into each hole. For masonry oors us a 3/16” masonry screw in place of the
provided screw, pilot drill per screw manufacturer’s recommendations.
For Architect Series Standard Installation Applications Only: Install sill screws. Remove
the threshold screws and insert a #8 x 3” stainless steel screw (provided) into each hole. For
masonry oors use a 3/16 masonry screw in place of the provided screw, pilot drill per screw
manufacturer’s recommendations.
SILL SCREWS FOR ARCHITECT SERIES PERFORMANCE UPGRADE AND
DOORS WITH HURRICANESHIELD IMPACTRESISTANT GLASS ARE
INSTALLED IN STEP 5.
I. For Low Prole Sills: through each installation
screw hole drill a 1/8” pilot; and install a #8 x 3”
corrosion resistant screw (provided) into the pilot
hole into the oor. For doors including a standard
lock install tubs per instruction included with the
sill strike package.
Note: For concrete oors use masonry screws that
are a minimum size of 3/16” diameter x 2” and
pilot per manufacturer’s recommendations for
the screw.
J. Remove sill strike screws from the sill strike
located on the door sill. Place a dab of sealant
into the three sill strike holes and install the three
#8 x 3” at head stainless steel screws (provided)
into the holes.
DOORS • ALL DOORS • ALL DOORS • ALL DOORS • ALL DOORS • ALL DOORS • ALL DOORS
Note: On In-Swing Door Standard Installation, sill screws are not needed.