Filter
Top Products
5
INSTALL THE FASTENERS FOR PERFORMANCE
UPGRADE OR HURRICANESHIELD PRODUCT
Frame Screw Method:
Note: If installing with installation clips,
proceed to Step E.
4
INTEGRATING THE DOOR TO THE
WATER RESISTIVE BARRIER
A. Jambs:
Out-swing: On the room side of the jamb;
drill and counter-sink 13/64” deep diameter
clearance holes through the door frame only
and not into the rough opening in the locations
shown. (See Out-Swing diagram in lower right).
In-swing: Open door panels; drill and counter-
sink 13/64” deep diameter clearance holes
through the door frame only and not into
the rough opening in the locations shown.
(On hinge jambs; clearance hole locations are
centered between hinges).
PERFORMANCE UPGRADE & HURRICANESHIELD DOORS • PERFORMANCE UPGRADE & HUR
EXTERIOR
INTERIOR
Drill 13/64" clearance
holes through the frame.
5A
Out-Swing
In-Swing
EXTERIOR
INTERIOR
EXTERIOR
INTERIOR
EXTERIOR
INTERIOR
Drill 13/64" clearance
holes through the frame.
Vent
Placement
Fixed
Placement
Vent
Placement
Fixed
Placement
5A
6"
16" MAX O.C.
16" MAX O.C. 6"
6" 6"
5A
6"
16" MAX O.C.
16" MAX O.C. 6"
6" 6"
In-Swing
Clearance
Hole
Location
Clearance
Hole
Location
Clearance
Hole
Location
Clearance
Hole
Location
6"
16" MAX
O.C.
16" MAX
O.C.
16" MAX
O.C.
16" MAX
O.C.
6"
6"
6"
6"
6" 6"
6"
DOUBLE OPERABLE
6"
6"
16"
MAX.
O.C.
6"
6"
16"
MAX.
O.C.
5E
5A
16" MAX
O.C.
16" MAX
O.C.
6"
6"
6" 6"
SINGLE FIXED OR OPERABLE
6"
6"
16"
MAX.
O.C.
5E
5A
5A
5B
5B
DIAGRAM FOR
PLACEMENT OF
FRAME SCREWS &
INSTALLATION CLIPS
Out-Swing In-Swing and Out-Swing
Out-Swing Vent or Fixed
In-Swing Vent
Out-Swing Vent and Fixed
Screw
Location
Out-Swing Vent or Fixed
In-Swing Vent
In-Swing Vent
Screw
Location
Hinge Jambs: See (5A) In-Swing
diagram (upper right). Fixed and
Lock jambs diagram for placement
of threshold screws and installation
clips (see out-swing diagram in
lower right).
B. Drill 13/64” deep clearance holes through the door frame head only and not into the rough
opening in the locations shown.
C. Drill 1/8” x 1” deep pilot holes through the clearance holes and into the rough opening
framing in the head, jambs, and threshold of the unit frame.
Note: Be certain to shim between jambs and rough opening at all screw locations.