Filter
Top Products
EXTERIOR FINISH
The exterior frame and sash are protected by aluminum cladding with our EnduraClad® or
EnduraClad Plus baked-on factory finish that needs no painting. Clean this surface with mild
soap and water. Stubborn stains and deposits may be removed with mineral spirits. DO NOT
use abrasives. DO NOT scrape or use tools that might damage the surface.
Use of inappropriate finishes, solvents, brickwash or cleaning chemicals will cause adverse
reactions with window and door materials and voids the Limited Warranty.
CARE AND MAINTENANCE
Care and maintenance information is available in the Pella Owner’s Manual. You can
obtain an owner’s manual by contacting your local Pella retailer. This information is also
available on www.pella.com.
IMPORTANT NOTICE
Because all construction must anticipate some water infiltration, it is important that the wall
system be designed and constructed to properly manage moisture. Pella Corporation is not
responsible for claims or damages caused by anticipated and unanticipated water infiltration;
deficiencies in building design, construction and maintenance; failure to install Pella products
in accordance with Pella’s installation instructions; or the use of Pella products in wall
systems which do not allow for proper management of moisture within the wall systems. The
determination of the suitability of all building components, including the use of Pella products,
as well as the design and installation of allow for proper management of moisture within the
wall systems. The determination of the suitability of all building components, including the
use of Pella products, as well as the design and installation of flashing and sealing systems are
the responsibility of the Buyer or User, the architect, contractor, installer, or other construction
professional and are not the responsibility of Pella.
Pella products should not be used in barrier wall systems which do not allow for proper
management of moisture within the wall systems, such as barrier Exterior Insulation and Finish
Systems, (EIFS) (also known as synthetic stucco) or other non-water managed systems. Except
in the states of California, New Mexico, Arizona, Nevada, Utah, and Colorado, Pella makes no
warranty of any kind on and assumes no responsibility for Pella windows and doors installed in
barrier wall systems. In the states listed above, the installation of Pella Products in barrier wall or
similar systems must be in accordance with Pella’s installation instructions.
Product modifications that are not approved by Pella Corporation will void the Limited Warranty.
$JSDMF)FBE
'VMM$JSDMF
5SBQF[PJE
0DUBHPO
"SDI)FBE 3FDUBOHMF
2VBSUFS$JSDMF
)BMG$JSDMF
0WBM
%PH)PVTF
3JHIU5SJBOHMF
Additional cutting patterns