Filter
Top Products
C2655M-A (10/08) 13
Figure 7. Assembling a Support Rail
3. Repeat step 2 for the other rail set.
4. If you are installing the unit into a square-hole rack: Insert 10 cage nuts into the square-hole rack as shown in Figure 8. Align the top and
bottom cage nuts on the front racks with the top and bottom cage nuts on the rear racks.
Figure 8. Inserting Cage Nuts
5. Attach one support rail assembly to the equipment rack in the desired location (refer to Figure 9):
NOTE: The support rail assemblies are identical and may be used on either the right or left side of the rack.
a. Position the ear of the front-mount rail against the front of the equipment rack. Align the top and bottom holes in the ear of the rail
with the threaded holes (or cage nuts) in the rack.
b. Using two 10-32 x 0.5-inch Phillips flat head screws, attach the ear of the rail to the front of the rack. Insert the screws from the
outside of the rack, pointing toward the back of the rack.
c. Adjust the rails to the correct depth of the equipment rack by sliding the rear-mount rail to the back of the equipment rack.
d. Position the ear of the rear-mount rail against the rear exterior of the equipment rack. Align the top and bottom holes in the ear of the
rail section with the threaded holes (or cage nuts) in the equipment rack.
e. Using two 10-32 x 0.5-inch Phillips pan head screws, attach the ear of the rail to the rear of the rack. Insert the screws from the
outside of the rack, pointing toward the front of the rack.
(3) SCREWS, 8-32 X 0.375
PHILLIPS TRUSS HEAD
REAR-MOUNT RAIL
CAGE NUT
FRONT-MOUNT RAIL
CAGE NUT