Filter
Top Products
C2216M (5/05) 7
PAXM100 POLE MOUNT ADAPTER
Install the PAXM100 to a steel pole with a diameter between 4 and 9 inches (10.16 to 22.86 cm). Refer to Figure 3 and perform the following
steps:
1. Attach the pole mount adapter to the pole with the four stainless steel straps (supplied). Tighten the clamps of the straps to 6.25 to
7.5 ft-lb (8.5 to 10.2 Nm).
2. Attach the WXM100 wall mount to the pole mount adapter with the supplied five 3/8-16 x 1.0-inch thread length, stainless steel hex head
bolts and stainless steel lock washers.
3. Secure the ExSite power module to the WXM100 with the 8 mm Allen wrench and four M10 x 16 mm stainless steel bolts supplied with the
power module. Tighten the bolts to 25 to 27 ft-lb (34 to 37 Nm).
4. Complete the ExSite system installation following the instructions supplied with the equipment.
Figure 3.
PAXM100 Installation