Filter
Top Products
C2216M (5/05) 5
Installation
WXM100 WALL MOUNT
To install the WXM100 refer to Figure 1 and perform the following steps:
1. Determine the mounting location. The mounting surface should be able to support four times the combined weight of the mount and ExSite
system.
2. Using the flanged end of the wall mount as a template, mark the five fastener hole positions onto the mounting surface. Set the WXM100
mount to the side and prepare the holes for the fasteners.
3. Position the wall mount over the mounting holes. Attach the mount to the mounting surface with the appropriate hardware (not supplied).
4. Secure the ExSite power module to the WXM100 with the 8 mm Allen wrench and four M10 x 16 mm stainless steel bolts supplied with the
power module. Tighten the bolts to 25 to 27 ft-lb (34 to 37 Nm).
5. Complete the ExSite system installation following the instructions supplied with the equipment.
Figure 1.
WXM100 Installation