Filter
Top Products
C3432M-F (6/08) 33
Reset Button
Use the reset button located on the board inside the back box to access the following modes:
To access one of these modes:
1. Press and hold the reset button. The unit starts cycling through the modes; hold the button for four
seconds to access (cycle through) each mode. The unit status indicator flashes the color for the
current mode (refer to the table above).
2. When the color of the desired mode appears, release the button.
NOTES:
• If there is no configuration activity for 15 minutes, the camera will automatically exit the reset
mode.
• The LED is not lit during normal operation.
Figure 27. Location of Reset Button and LEDs
Mode Function Unit Status Indicator Light
Configuration Starts reset LED
selection sequence.
Flashes green.
Reboot Restarts the unit. Flashes green and red simultaneously, when entering
this mode. The LED then flashes green when mode is
selected and during the reboot.
Reset Resets unit to factory
default settings and
then restarts unit.
Flashes red when entering this mode. Flashes red when
mode is selected, and then flashes green when camera
restarts. Camera is offline during reset mode.
Cancel Cancels any
configuration or reset
action.
No light.
RESET
BUTTON
RED / GREEN LEDS