Filter
Top Products
20 C3432M-F (6/08)
MODULE INSTALLATION
To install the camera module into the back box:
1. Plug the camera (10-pin), heater board (4-pin), and service (3-pin) connectors into the back box (refer
to Figure 16).
Figure 16. Back Box Connectors
2. Make sure the tabs on the camera bracket and the service connector are pointing out of the
enclosure, away from the ceiling or wall.
3. Gently squeeze the bracket, place it against the groove inside the back box, and then gently release
(refer to Figure 17).
Figure 17. Camera Module Bracket
HEATER
CONNECTOR
SERVICE
CONNECTOR
CAMERA
CONNECTOR
BRACKET