Filter
Top Products
TO REPLACE BELT
➢
Install new belt in belt path on the
agitator assembly, then over the
motor shaft. (See CONSUMABLE
PARTS for belt number, p. 11)
➢
Place agitator assembly back into
Power Nozzle.
➢
Line up front of cover and base. Rest
cover on front edge of base as
shown.
➢
Rotate cover back. Press cover
firmly until side and rear latches snap
into place.
➢
Make sure there is no gap between
the cover and base.
➢
Turn Power Nozzle upside down and
replace two (2) cover screws.
Side Latch
Pestillos laterales
Loquet latéral
Rear Latches
Pestillos traseros
Loquets arrière
Motor Shaft
Arbre du moteur
Impulsor del motor
Belt Path
Chemin de courroie
Ruta de la correa
End Cap
Bouchon
Tapa del extremo
Agitator
Agitateur
Agitador
Base
Base
Base
Cover
Couvercle
Cubierta
➢
Lift agitator assembly out and remove
worn belt.
➢
Clean agitator and the end caps (see
AGITATOR AGITATOR, p. 44).
Base
Base
Base
End Cap
Bouchon
Tapa del extremo
- 42 -