Filter
Top Products
13.4.2.5. Removal of Propeller Fan and
Fan Motor
1. Remove the Cabinet Top Plate and Cabinet Front Plate
according to the item 13.5.2.1.
2. Remove the Control Cover (Control Board Upper Cover) by
releasing the hooks (four: two each on the both sides).
Fig. 14
3. Remove only the Connector for the CN-MTR1 and CN-
MTR2 (Outdoor Fan Motor).
4. Remove the Propeller Fan by turning the nut in the center
of the fan clockwise.
Fig. 15
5. Remove the Fan Motor by loosening the screws (four).
Fig. 16
Note for Reassembly:
Adjust each position of the Boss in the center of the
Propeller and the groove on the shaft of the Motor when
putting them together.
Fig. 17
73
CS-TE9DKE CU-TE9DKE / CS-TE12DKE CU-TE12DKE