Filter
Top Products
over the top of the pigtail on
the power cord (
fig 1).
8. To install cord strain relief
(22), hold power cord
7-8 inches from plug. Pinch
power cord together and
slide approximately
1-2 inches through hole in
cord strain relief. Carefully
slide power cord over clamp
on the cord strain relief and
pull excess until the power
cord is tightly rested under
clamp. (
fig 2).
9.
Attach cord stain relief with power cord attached to the back of
the unit using the M5 thumbscrew (
fig 3).
4
Assembly
1. Install handle by sliding it into the opening in the top of the bag
housing until it bottoms out. Install and tighten with the M5
thumbscrew (21).
2. Install the hose by pushing one end into the top of the bag
housing. Push the other end into the wand.
3. Position the open end of wand over the opening of the power
brush housing and push the wand into the sleeve in the back of
bag housing until it snaps into the notch.
4.
Plug the Cord Pigtail (lower power cord) into the bag housing.
5. Make sure the dust bag is installed. For instructions refer to the
“Dust Bag Removal and Installation”.
6. Snap two of the tools into the option mount.
7.
T
o secure the power cord to unit, plug the power cord into the
outlet at the top of the vacuum housing. Slide cord restraint (23)
Parts List
To assist you in identifying components of your
vacuum, the parts have been numbered as follows:
1
2
3
4
5
6
7
8
9
10
1
1
12
13
14
15
16
17
18
19
20
1. Handle
2. Option Mount
3. Full Bag Light
4. Main Power Switch
5. Door Latch
6. Bag Housing
7. Release Handle
8. Electronic Display
9. Handle Pivot
10. Brush Housing
11. Power Brush
Housing
12. Hose
13.
Upper Cord Hook
14. Power Cord
15. Wand
16. Transport Handle
17. Thumb Nut
18. Base Inlet
Connector
19. Cord Pigtail
20. Rear Wheel
21. M5 Thumbscrew
22. Cord Strain Relief
23. Cord Restraint
24. Dusting Brush
25. Upholstery Brush
26.
Crevice Tool
24
25
26
21
22
23
1
Cord
Restraint