Filter
Top Products
- 5 -
3. CLEANING & STORAGE
3.1 CLEANING BRUSH ROLL
In order to keep high cleaning efficiency and to prevent damage to your vacuum
cleaner, the brush roll must be cleaned every time the belt is changed.
The brush roll must also be cleaned according to the following schedule:
V
ACUUM CLEANER USE CLEAN BRUSH ROLL
Heavy (used daily) Every week
Moderate (2-3 times per week) Every month
Light (1 time per week) Every 2 months
Check and remove hair, string and lint build-up frequently in the brush roll and end
cap areas. Remove any dirt or debris in the belt path and in the brush roll areas.
3.2 CLEANING HOUSING
To keep the power brush housing clean, it can be wiped with a damp cloth and a
mild soap solution, then thoroughly dried. Never use any type of chemical as they
can damage the housing.
3.3 STORAGE
1. Ensure that hose and power cord are disconnected from wall inlet before
unplugging power brush.
2. Disconnect hose handle from wand.
3. Always keep hose neatly coiled when not in use.
4. When not in use, the power brush should be stored in a clean, dry place.
WARNING
Disconnect electrical supply before servicing or cleaning the unit.
Failure to do so can result in electrical shock or personal injury
from cleaner suddenly starting.
!
2. HOW TO USE POWER BRUSH/WAND (continued)
2.6 ELECTRONIC CIRCUIT BREAKER
The power brush is equipped with an electronic circuit breaker that protects the
motor and the belt if a too large object is picked up accidentally.
If the power brush stops while vacuuming, turn the
power unit off using handle. Release the power
brush from the wand and turn it over to see if there
is an obstruction. When brush roll jam has been
cleared, press the reset button (H) and connect
the power brush back to the wand. Finally, turn the
power unit/power brush back on. If it fails to restart
or continues to trip without any apparent reason,
the power brush must be serviced by an authorized
service center.
AD0030
H