Filter
Top Products
54 Appendix E Using Element Manager to set the basic parameters
N0060603N0060603
5 Configure the attributes for Modify SNMP Settings (see Table 13).
6 Click Ok.
To configure SNMP community strings
1 From the Configuration tab, click the Administrator Access folder to expand it.
2 Select SNMP from the Administrator Access folder.
3 Select the Community Strings tab.
4 Click Add.... The Add Community String dialog box opens.
5 Configure the Add Community String attributes (see Table 14).
6 Click Ok.
7 Repeat steps 4 to 6 to add more community strings.
To configure the SNMP manager list
Use the SNMP manager list to specify IP addresses that are allowed to connect to the SNMP agent.
1 From the Configuration tab, click the Administrator Access folder to expand it.
2 Select SNMP from the Administrator Access folder.
3 Select the General tab. It is normally selected by default.
4 Click Add... in the SNMP Manager List area. The Add Manager dialog box opens.
5 Enter the IP address in the Manager IP Address field.
6 Click Ok.
7 Repeat steps 4 to 6 to add another manager IP address.
Table 13 Modify SNMP Settings attributes
Attribute Description
Enable SNMP Agent Select whether to enable or disable the SNMP agent by selecting (or not
selecting) the check box.
Minimum required security Select the minimum required security for SNMP from the drop-down list.
SNMP Version Support Select the SMNP version support from the drop-down list.
Table 14 Add Community String attributes
Attribute Description
Community string Enter the entry name used as a key to uniquely identify an individual
community entry on the SNMP agent.
Type of access Specify the read and write access for this community. Available options are
Read Only and Read/Write.