19
W415-0536 / C / 09.06.06
1. Carefully remove the glass door and all logs. (Refer to
the installation manual)
2. Remove the two screws holding the front portion of the
. Remove the pilot shield by removing the
two screws as illustrated. (Fig. 42)
3. Remove the 3 screws holding
the burner down and carefully
remove the burner. (Fig. 43)
4. Install the right brick panel by sliding the bottom edge of
dge
with the brick retainers. (Fig. 44)
Note: Due to the brittle material of the bricks, care must
be taken not to bend or force them into place.
Note: Refractory panels require a 24 hour curing period
on a low ame.
32
1
HERRINGBONE PATTERN ILLUSTRATED
STEP
#3
5. Rest the bottom edge of the rear panel on top
held in place when both side panels are in position.
6. Install the left brick panel using the same method
described in step 4.
STEP
#2
PILOT SHIELD
DECORATIvE BRICK PANEL INSTALLATION
FIGURE 42
FIGURE 43
FIGURE 44
FIGURE 45