17
W415-0100 / D / 01.13.04
INSTALLATION TO BE DONE BY A QUALIFIED IN-
STALLER and must be electrically connected and grounded
in accordance with local codes. In the absence of local
codes, use the current CSA C22.1 CANADIAN ELECTRICAL CODE
in Canada or the ANSI/NFPA 70 NATIONAL ELECTRICAL CODE in the
United States.
The three slots on the
blower mounting
bracket allow ease of
adjustment when
attaching the blower.
For a quiet running
blower, do not allow the
assembly to sit on the
firebox base.
Slide the vibration reducing pad
(A) into the clip (C) and up against
the threaded stud (B) at the other
end. The blower must be able to
be positioned entirely onto the
pad.
Tilt the blower onto its
side. Slide it past the
controls and into the
clip (C). Secure to the
threaded stud using
the lock washer and
wing nut provided. En-
sure that the blower
does not touch the fire-
place base or the fire-
box.
Attach the connectors from the black and white wires to the
thermodisc and secure the thermodisc bracket to the se-
curing stud at the bottom left of the unit using a lock washer
and wing nut. Ensure that the thermodisc touches the fire-
box wall.
Attach the connectors from the black and red wires to the
blower.
Attach and secure the variable speed switch using the nut
provided. Plug the harness cord into the receptacle.
The wire harness provided in this kit is a universal
harness. When installed, ensure that any excess
wire is contained, preventing it from making con-
tact with moving or hot objects.
Because the blower is thermally activated, when
turned on, it will automatically start approximately
10 minutes after lighting the fireplace and will run
for approximately 30-45 minutes after the fireplace
has been turned off. Use of the fan increases the
output of heat.
Drywall dust will penetrate into the blower bear-
ings causing irreparable damage and must be pre-
vented from coming into contact with the blower
or its compartment. Any damage resulting from
this condition is not covered by the warranty
policy.
FIGURE 40
C
B
A
FIGURE 35
FIGURE 36
FIGURE 39
FIGURE 38
FIGURE 37
OPTIONAL BLOWER INSTALLATION