Filter
Top Products
Introduction
Congratulations
on your purchase of an advanced NAPCO EXPRESS XP-400 Security System. Meticulously developed
by a leading manufacturer of state-of-the-art security products, this system will provide you with unprecedented peace-of-mind &
incorporates some of the most sophisticated features available today. Above all, it has been designed an extra step, to provide
all those operating it with very easy, intuitive use. Please carefully review the information contained in this manual, so that you
and all potential users of the system familiarize yourselves with its operation, and can therefore take full advantage of EXPRESS’
many convenience features and amenities.
Your system
consists of a control panel (a computer housed within a white metal panel enclosure), one or more EXPRESS
Decorator Keypads for controlling the system, and various security detection devices. These detection devices are divided
among separate areas known as “zones”, set up throughout your premises. Each zone number corresponds to a Zone light on
your Keypad’s gray display area.
When a zone’s red light is ON (or lit), it indicates that one or more detection device(s) assigned to that area are active or open.
For example, if Zone 1 is the front door, and it is open, the Zone 1 light will be on. If zone 2 is a motion detector, and there is
movement in that area, Zone light 2 will turn ON. Depending upon the actual layout your security professional has chosen to
properly protect your premises, each zone may function a little differently: The zone protecting your front door may be
programmed as an Exit/Entry zone to allow you time to enter the premises disarm the system , without inadvertently sounding
the alarm. Alternatively, a zone protecting a window could be designated as an “instant” zone, so that if it is entered or opened
while the system is on/armed, there will be an immediate alarm.
Your easy
NAPCO EXPRESS Keypad
puts super-simple system control at your fingertips.
Most keypad commands
involve entering your four digit User Code. This includes Arming (or activating) and Disarming (or deactivating) the system.
Simply put, ARMED means the system is ON; DISARMED means the system is OFF. If the system is OFF and you want to turn
it ON, just enter your Code. To turn the system back OFF, enter your code again.
It’s easy, just always remember, in the
event of an alarm, entering your User Code will silence all Sirens.
Your keypad is your command and status center, it keeps
you informed visibly, using its zone and status lights (in the gray display area) and audibly, using its built-in keypad sounder. For
more information, please see Keypad Controls and Indicators on page 5.
3
Oi220a
page 3
Tuesday, September 16, 1997 08:30