Filter
Top Products
7
K
˘
5 Using a flat bladed screwdriver or a coin,
rotate the three cover fixings, a quarter of a
turn, from lock to unlock J.
6 Lift the base cover, from the rear fixing area
first, the cover will rotate forward. Unhook
cover from front edge and remove N.
Removing rotating brush & belt
L
7 Lift the metal belt guard ˘ out of the floor
nozzle and put it safely to one side K.
8 Slide the belt past the end of the motor drive
shaft. If the belt has broken remove al pieces
and clean the drive shaft.
9 Lift the rotating brush equally at both ends
to slide it free of the floor nozzle L. Holding
the ends of the brush check it rotates freely
if not, it must be replaced. Call our Helpline
for replacement parts or belts.
Re-fitting rotating brush & belt
M
10Hook the belt over the the drive shaft (the
belt must be slid sideways past the end of
the drive shaft). Note: Belt guard must have
been removed first, see 7 above.
11Refit the belt guard, ensuring it is correctly
located. Press down fully.
12Pass the rotating brush through the belt
ensuring the correct end is located against
the belt M.
13Pull the brush forward (against the pull of the
belt) and locate the square ends of the brush
into the location slots in the floor nozzle M.
14Rotate the brush by hand to ensure the belt
is running in the center of its location on the
brush.
Refitting floor nozzle base cover
N
15Hook the base cover into the front of the
floor nozzle, ensuring all four hooks are
engaged N.
16Rotating the cover downwards and
rearwards, slowly close the cover.
M
L
J
N
VC73360MUK-CyclonicBaglessRev3 3/11/05 4:41 pm Page 7