Filter
Top Products
18 70D0004
INSTALLING VENTED APPLICATIONS
PLACING AND SECURING APPLIANCE
ASSEMBLY PROCEDURE:
1. Center the gas log unit on the fireplace or firebox. Make certain the front of the burner sits inside the front edge of the
fireplace or firebox.
2. Anchor holes are located on the right and left sides of the unit. After centering the burner correctly, mark the hole posi-
tions on the fireplace/firebox floor. Drill two (2)
5
/32" diameter holes approximately 1
1
/2" deep.
3. Anchor the burner to the fireplace/firebox floor using the screws provided. See Figure 14.
Proper installation of the grate is essential to prevent any movement of the gas logs and controls during operation.
Figure 14 - Securing Heater to Floor of Fireplace/Firebox
Screw
Anchor Hole
Screw
WARNING
You must secure the gas log heater to the fi replace fl oor. If not, the entire unit may move
when you adjust the controls. Movement of unit may cause shifting of the gas logs which
leads to sooting and improper burning. Grate movement could cause a gas leak.
Special care is required if you are installing the unit into a sunken fi replace. You must raise
the fi replace fl oor to allow access to gas log controls. This will insure adequate air fl ow
and guard against sooting. Raise the fi replace fl oor using noncombustible materials, as
described in Placement in a Fireplace with Restrictive Barrier on page 10.