Filter
Top Products
54D5031 31
ON
OFF
OPTIONAL REMOTE
RECEIVER
ON
OFF
RS
PILOT
HI
LO
ON
OFF
TH
TP
TH/TP
ON
OFF
OPTIONAL WALL
SWITCH
GRAY
BLUE
BLACK
BLACK
BLACK
BLUE
WHITE
RS
REMOTE WALL SWITCH
Position the wall switch. Do not extend beyond the 15 feet of wire.
OPTIONAL DC REMOTE SYSTEMS
These instructions replace the section entitled Hearth Mount in the Millivolt hand held remote instructions supplied with
the remote.
1. Plug in remote connector wire to remote receiver.
2. Connect the wire terminal from the remote receiver. This replaces the 15' wall switch connection to the switch. See
Figure 42.
3. Mount remote control receiver at junction box (for your wall switch).
OPTIONAL FAN/BLOWER
SYSTEMS
The junction box for the fan/blower
systems has been factory installed. This
system requires that 110-120 VAC to be
wired to the factory installed junction
box before the fireplace is permanently
installed. See Figure 43.
TANTANWHITE
GREEN
BLACK
BLACKBLACK
SPEED CONTROL
OPTIONAL THERMOSTATIC SWITCH
REMOTE WALL MOUNTED SWITCH
A remote wall switch and up to fifteen (15) feet of 18
gauge wire may be used with this appliance. Attach the
wall switch in a junction box at the desired location on the wall. See Figure 42. Do not extend beyond the wall switch wire
length provided.
NOTE: Extended lengths of wire may cause the fi replace not to function properly. Longer length of wire
is permitted if the wire is made out of larger gauge (diameter) wire. Always check with local code.
Figure 42 - Wiring Diagram for Wall Switch
ELECTRICAL INSTALLATION
Figure 43 - Blower Wiring Diagram
Do not connect 110V to wall switch.
WARNING