Filter
Top Products
8
Operating the Controls
Where you set your desired humidity levels
depends on your personal comfort level, outside
temperature and inside temperature. A starting set
point of 30% - 40% ROOM humidity is
recommended but there may be conditions that
require a different setting.
IMPORTANT: Water damage may result if
condensation starts to form on windows or
walls. Humidity SET point should be lowered
until condensation no longer forms. We
recommend room humidity levels do not
exceed 50%.
-10° F
2° F
10° F
20° F
-24° C
-18° C
-12° C
-6° C
20%
25%
30%
35%
When Outdoor Recommended Indoor
Temperature is: Relative Humidity is:
* and above
To Operate the Controls
Digital Display
Press the power/speed button once to turn the unit
on* . Initially there is a slight delay while the
electronics calibrate. Two bars (- -) appear during
this time. Once calibration is complete a ROOM
humidity reading between 20% - 95% will be
displayed. A flashing 20 display indicates that the
room humidity is less than 20%.
NOTE: The default settings at initial startup are
(Ultra Quiet) F1 fan speed and 65% SET humidity.
After desired settings are selected by the user,
they remain as long as the unit remains plugged in
and there is no power interruption. If the unit is
unplugged the original default settings are
employed.
* Humidifier fan should operate at initial start up. If it
does not, refer to, “Fan not operating (digital display is
illuminated)” in the “Trouble Shooting” section on page
14.
Speed Button
This humidifier is equipped with a
3-speed fan control. Initially depressing the speed
button will display the current speed setting. Each
push of the speed button advances the mode
through the settings of (HIGH) F3, (MEDIUM) F2,
and (Ultra Quiet) F1.
The selected setting is displayed on the digital
readout. The higher the setting, the faster water is
evaporated and released into the air. F1 (Ultra
Quiet) is the quietest setting and is provided for
conditions that do not require a rapid evaporation
rate.
Humidity Control
This button allows you to adjust the humidity to suit
your needs. This humidifier will automatically cycle
on and off as required to maintain the selected
setting. The readout displays both actual (ROOM)
and desired (SET) humidity percentage (%) settings
when humidity control button is pressed. The
ROOM readout has a range of 20% to 95%. If the
room humidity level is equal to or less than 20% the
display will show a flashing 20.
*
*
QUARKSP6647 HD14070:SP6647 .qxd 12/10/2009 3:39 PM Page 8