Filter
Top Products
7
Water Fill (continued)
Each water bottle is designed with a “Side-Fill
Cap” that is easily removable. Remove the “Side-
Fill Cap” on the side of the water bottle by twisting
counterclockwise.
Place the opening of the water bottle under a
water faucet (the bottle should fit under a four-inch
clearance faucet). Fill with recommended mixture
of cold water and Bacteriostat (if necessary) only.
Solid debris could make the valve leak.
Install the “Side-Fill Cap” by twisting clockwise.
Hand tighten only.
Check for possible leaks by performing the
following:
1. Grasp bottle handle and hold the bottle upright
over a sink.
2. Press up on the valve cap plunger for about
one second to let out a little water.
3. Release the plunger.
4. Listen for air bubbles Look for leaks around the
“Side-Fill Cap”.
5. If you hear air bubbles or see leaks, retighten
the “Side-Fill Cap” and repeat Steps 1-4.
Wipe off excess water from the bottle.
Position the water bottle back into the unit by
grasping the water bottle handle and lower it into
the cabinet until the bottle sits on pads at bottom
of cabinet. The “Side-Fill Cap” must be facing the
rear of the cabinet. When positioned properly, the
plunger will open and water will flow into the
cabinet. The water level will automatically remain
at approximately 1/2” until the bottles are empty.
Allow the filter to saturate for 30 minutes before
operation.
QUARKSP6647 HD14070:SP6647 .qxd 12/10/2009 3:39 PM Page 7