Mitsubishi Electronics SRF50ZMX-S Air Conditioner User Manual


 
–25–
Airoutlet selection
In case both lower and upper outlets operation with Auto fan speed mode is selected, the
lower outlet will be kept for twenty minutes after the start or until room temperature is close
to reaching the setting point . And then the air outlet will change to both outlets. That state
will be maintained until the switch is turned off.
Automatic adjustment of lower air outlet direction prevents stirring up of warm air and
keeps optimum comfort at floor level.
HEAT operation
COOL, DRY operation
In case both lower and upper outlets operation is selected in Cooling or Dry operation, both
outlets will be kept for sixty minutes after the start or until room temperature is below the
setting point. And then the air outlet will change to the upper outlet. That state will be
maintained until switch is turned off.
In case both outlets operation with Auto fan speed mode is selected, the upper outlet will
be kept for ten minutes after the start or until room temperature is close to reaching the
setting point . And then the air outlet will change to both outlets in order to spread comfort
air to every corner.
Auto airoutlet selection
1
2
Press the ON/OFF button on the remote control.
AIR SELECTION button can switch between the combination of upper and lower air outlets and upper air outlet. Not operable while the
air conditioner is OFF.
Press the AIR SELECTION button on the unit display
section.
Each time the AIR SELECTION button is pressed. The combination of the
upper and lower air outlets and the upper air outlet can be switched.
When the upper air outlet is selected, AIR OUTLET SELECTION light on
the unit display area will light green.
AIR OUTLET SELECTION
light : OFF
AIR OUTLET SELECTION
light : ON
Upper air outlet
Upper and lower air outlets
RFB012A006C_EN_001-032_0409 4/9/14, 9:4025