Filter
Top Products
–14–
Airflow direction adjustment
Adjusting airflow direction
■ Up/down direction can be adjusted with the AIRFLOW U/D(UP/DOWN) button on the remote control. Every time you press this
button the mode changes as follows:
Change on AIRFLOW (UP/DOWN) mode.
MEMORY FLAP (FLAP STOPPED)
When you press the AIRFLOW button once while the flap is operating, it stops swinging at the position. Since this angle is memorized in the microcom-
puter, the flap will automatically be set at this angle when the next operation is started.
WARNING
• Do not expose directly to airflow from the air-conditioner for a long time.
CAUTION
• When in COOL or DRY operation, do not operate for a long period with the
airflow blowing straight down. Otherwise, condensation may appear on
the outlet grill and drip down.
• Do not try to adjust the flaps by hand, as the control angle may change or
the flap may not be closed completely.
HEAT
(Horizontal
blowing)
(Slant forward
blowing)
COOL, DRY
• Recommended angle of the flap when
stopping
• When operation starts, the flap direction is fixed at the horizontal position in order to avoid cold draft, and return to the set the
position that was set after the warm air supply is starting.
• The flap direction will be controlled to the horizontal position when the room temperature reaches the set temperature and com-
pressor stops or when defrosting is in operation.
• The airflow direction cannot be set during the period mentioned above. Change the airflow direction settings after the warm air is
supplied and the flap goes to the set position.
(Swing)(Flap stopped)
NOTE FOR HEATING OPERATION
• The actual position of the flap may differ from the display shown.
CAUTION
• When adjusting the air flow direction, be careful with the
fans rotating in the air conditioner.
Otherwise you may injure your fingers.
• The lower flap is not adjustable while the air conditioner is
OFF.
Adjusting left/right air flow direction
Adjust the direction by moving the left/right
air flow fin by hand.
NOTE
RFB012A006C_EN_001-032_0409 4/9/14, 9:4014