Filter
Top Products
– 10 –
REPLACING PARTS
HOW TO REPLACE - DRIVE BELT
(Part # S01Z6000) AND BEATER BAR
ASSEMBLY (Part # R98M9064)
1. Remove the 5 screws from the base plate
and lift it off. (Fig. 1)
2. Release the belt from the motor shaft and
lift the beater bar assembly to remove the
belt. (Fig. 2)
3. To reassemble the beater bar assembly,
simply return the belt to the motor shaft and
beater bar pulley.
Re-insert the bar mounts into their holders,
and turn the beater bar to ensure that the
belt has been seated correctly. (Fig. 3)
IMPORTANT: Make sure the belt is correctly
positioned in the selector lever.
4. Replace the base plate and re-fasten the
screws securely.
2
3
1
4
5
1 - Beater bar
2 - Side brush B
3 - Side brush A
4 - Bearing support A
5 - Bearing support B
Fig. 2
Fig. 3Fig. 1
Fig. 2Fig. 1
Use only genuine Miele replacement parts.
DISCONNECT THE CLEANER FROM THE ELECTRICAL SUPPLY.
If you have any questions, contact your local dealer / service agent.
Any service needed other than described in these Operating Instructions should be
performed by a Miele Service Center only.
To replace any of the following parts, place the vacuum cleaner in the horizontal position
by using the pedal. Then turn it over exposing the underside.
HOW TO REPLACE - BEATER BAR /
SIDE BRUSHES / BEARING SUPPORT A-B
1. First remove the base plate, drive belt and
lift out the beater bar assembly (as illustrated
above).
2. Remove the 2 screws at both ends of the
beater bar assembly and separate the
different parts as shown in the exploded view.
3. Replace any damaged part and reassemble
in reverse order.
HOW TO REPLACE HEADLIGHT BULB
1. Loosen the 2 screws from the lens cover
and remove it. (Fig.1)
2. Remove the old bulb by simply pulling it
forward, and replace it with a new one.
(Consult your local dealer /Service agent
for a suitable bulb) (Fig. 2)
3) Replace the lens cover and re-fasten
the screws securely