Filter
Top Products
– 8 –
FILTER CARE
In addition to the dust bag, the vacuum cleaner
contains two filters; a central filter that protects
the motor (Fig.1) and a HEPA Filter, that removes
particles from the exhausted air (Fig. 2).
The HEPA Filter should be changed every six
months or whenever it becomes dirty. The central
filter should be changed or rinsed out whenever
the HEPA Filter is replaced.
CENTRAL FILTER (Fig. 1)
Part # F03M1000
To remove, slide the central filter forward out of this
housing.
IMPORTANT: If the central filter has been rinsed
out, make sure it is dry before re-installing it.
HEPA FILTER (Fig. 2)
Part # S02Z6000
To change the HEPA Filter, simply remove the
exhaust cover as shown and replace the filter.
IMPORTANT: Do not forget to re-install the
filters before use.
WALL - TO - WALL CLEANING
AUTOMATIC BEATER BAR STOP
AUTOMATIC CARPET HEIGHT ADJUSTMENT
WALL - TO - WALL CLEANING
AUTOMATIC BEATER
BAR STOP
AUTOMATIC CARPET
HEIGHT ADJUSTMENT
Fig. 1
REPLACING THE DUST BAG
1) Push the release
button on the dust
cover as shown, and
pull it forward.
2) Grip the handle
of the dust bag
and pull out.
3) Close dust bag
tab to avoid dust
leakage and put it
away.
We recommend the use of genuine Miele paper bags only; Part # 05294 741 Type Z
CAUTION: DISCONNECT THE CLEANER FROM THE OUTLET
BEFORE PERFORMING THE OPERATIONS BELOW
NOTE: If the dust bag is not installed correctly, the dust cover will not close.
5) Replace the dust
cover by inserting
the tab into the body
slot then push the
top of the cover into
place.
4) Install the new
dust bag by placing
the hole over the
exhaust port and
pressing it into
place as shown.
Fig. 2