Filter
Top Products
Section 2
2-10
Installation Instructions
Connection to Ice Machine (cont.)
COMMUNICATION WIRE CONNECTION
Insert the low voltage communication wire through
the ½” conduit connecting the AuCS
A to the ice
machine.
A to the ice
machine.
Plug into the jacks on the ice machine control board
and the AuCS
A control board. (Refer to drawing for
routing communication wire in ice machine.)
Plug into the jacks on the ice machine control board
and the AuCS
A control board. (Refer to drawing for
routing communication wire in ice machine.)
CONTROL BOARD
COMMUNICATION
WIRE
GROUND WIRE
(Q1300/Q1800 ONLY)
ROUTE WIRING
THROUGH
ACCESS HOLES
AS SHOWN
COMMUNICATION
WIRE
30 AND 48 INCH 22 INCH
SV1642G
Low Voltage Communication Wire Connection
QDUAL ONLY: The communication wire is attached to the rear of the ice
machine control box. The communication wire included with the
AuCS
A is
not used.
AUCS CONTROL
BOARD
COMMUNICATION
PORT
QDUAL
COMMUNICATION
PORT