Filter
Top Products
Stopper
block
.The stopper block has an adjustment hex
bolts which move
1
mm
(1/32")
per turn.
After obtaining the desired depth setting,
tighten the hex nut on the bolt with the
spanner.
\
block
I
Nylon nut
By
turning the nylon nut, the upper limit
of
the tool can be adjusted. When the tip
of the bit
is
retracted more than required
in relation to the base plate surface, turn
the nylon nut to lower the upper limit for
more effective routing.
CAUTION
:
0
Do
not lower the nylon nut too low or the bit will dangerously protrude.
0
Before operating the tool, check to be sure that the router automatically rises to the
upper limit.
Switch action
*To
start the tool, position the switch
lever
to
"ON" side.
To
stop, to
"OFF"
side.
CAUTION
Prevent accidental starting by making
sure the tool
is
switched off before you
plug
it
in.
Switch
lever
6