Filter
Top Products
Installing
bit
0
Loosen the collet nut and insert the bit
into the chuck hole. Press the shaft lock
and use the wrench to secure the bit care-
fully. Use the collet
sleeve
if necessary.
I
CAUTION
:
0
Do
not tighten the collet chuck without inserting
a
bit; do not install
a
small bit with-
out using
a
collet
sleeve.
Either can lead to collet chuck breakage.
Adjusting cutting depth
Release the lock lever and lower the tool
to the desired depth. Then pull up on the
lock lever to lock.
Now
adjust the stopper
block and pole
so
that, even if the lock
lever
is
released, the router stops
at
the
uniform depth.
If you press the fast-feed button on the
stopper pole, the pole can be advanced
rapidly. Ordinarily the pole moves
1.5
mm
(1/16”)
per turn. Minute depth adjust-
ments can be obtained by raising or
lowering the stopper pole.
5