Filter
Top Products
ADDITIONAL SAFETY RULES
1.
These bits come fully sharpened. Handle them carefully to prevent injury.
2.
Check the bit carefully for cracks or damage before operation. Replace
3.
Avoid cutting nails. Inspect for and remove all nails from the workpiece be-
4.
Make sure the shaft lock is released before the switch is turned on.
5.
Hold the tool firmly with both hands.
6.
Keep hands away from rotating parts.
7.
Check the bit
is
not contacting the workpiece before the switch is turned on.
8.
Before using the tool on an actual workpiece, let
it
simply run for several
minutes first. Watch for flutter that might
be
caused by poor installation or
a poorly balanced.
cracked or damaged bit immediately.
fore operation.
9.
Be careful of the bit rotating direction and the feed direction.
IO.
Do
not leave tool running. Operate the tool only when hand-held.
11.
Always switch off and wait for the bit to come to a complete stop before
12.
Do
not touch the bit right after operation,
it
is extremely hot and could burn
13.
Keep the bit retracted
so
as not to protrude from the bottom except during
removing the router from workpiece.
your skin.
actual operation.
SAVE THESE INSTRUCTIONS.
4