Filter
Top Products
MAINTENANCE
CAUTION
:
Always be sure that the tool
is
switched off and unplugged before attempting to perform
inspection and maintenance.
Replacing carbon brushes
0
Remove and check the carbon brushes
regularly. Replace when they wear down
to about
6
mm
(1/4")
or
less.
Keep the
brushes clean and free to slip in the
holders. Both brushes should be changed
at
the same time. Use only Makita carbon
brushes.
0
Use
a
screwdriver to remove the brush
holder cap
as
shown on the figure.
.Take out the worn brush, insert the new
one and secure the brush holder cap.
k4
6
mm
(1
/4")
BNSh
holder
cap
Any other maintenance should be performed by an Authorized Makita Service Center or
point of purchase.
10