Filter
Top Products
11
Post Installation Checks
1. Check that all chimney pipe joints are securely fastened.
2. Check that the heater is securely fastened to the floor (if
applicable).
3. Make sure the intake vent has clear access to outside air
(if applicable).
4. Make sure the outside air vent has been sealed properly
to keep rodents out (if applicable).
5. Be sure all roof flashings are watertight.
6. Be sure the stove is properly grounded (if applicable).
FOR YOUR OWN PROTECTION AND INSURANCE
PURPOSES, HAVE YOUR CHIMNEY AND CONNECTOR
PIPE INSTALLATION INSPECTED BY YOUR LOCAL
BUILDING CODE AUTHORITY OR FIRE MARSHAL
BEFORE STARTING A FIRE IN YOUR STOVE. NOTIFY
YOUR INSURANCE COMPANY.
Brick Installation
CAUTION: Wear gloves during brick installation in case
of sharp edges inside the stove.
Note: Installation of the baffle bricks and insulating blanket is
easier when you can still access the flue outlet, (before con-
necting the flue pipe). Be sure the insulating blanket is placed
flat on the bricks so as not to block the flue. Use a ruler or a
piece of kindling to reach over the blanket to be sure it is com-
pletely flat on top of the baffle bricks.
Measure bricks before installing, as per list of dimensions on
next page, to be sure the correct bricks are installed in the cor
-
rect location.
1. Install bricks #1-26 in the numbered sequence shown in
Figure 6 on Page 12.
Note: Before installing your baffle bricks make sure the
stainless steel tube support and front and rear tube hangers
are centered side to side and that the front and rear hangers
are hooked onto the stainless steel pins protruding from
the rear of the airwash and the stove back.
2. Next, install bricks #27-38 on top of the stainless steel
secondary burn tubes in the upper part of the firebox.
Bricks #27-32 fit up against the back wall of the firebox
and rest on top of bricks #24-26 and the rear secondary
tube. The stainless steel support hanger should be centered
between the sets of baffle bricks as shown in Figure 8 on
Page 12.