Filter
Top Products
12
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Ceramic Fiber
Blanket
Baffle Bricks Top View
Figure 7
Brick Sizes
A = 4-1/4” x 9”
B = 2-1/4” x 8-7/8”
C = 3-1/2” x 9”
D = 2-1/4” x 9”
E = 1-1/2” x 8-7/8”
F = Full Brick (4-1/2” x 9”)
G = 1-1/2” x 9”
H = 3-1/2” x 8-7/8”
Figure 6
3. Next, install baffle bricks #21-24 by sliding the back of
each brick over the center tube and support until the front
of the brick clears the front tube and support. Then lift
the front of the brick above the front support and tube
and slide it forward as far as it can go (very important),
it will hit the front of the stainless support when it is fully
forward. The rear of the bricks sit on top of bricks #19-20
(Figures 7 and 8).
4. Carefully slip the ceramic blanket up over the front of
the front stainless support and bricks #21-24. Grasp the
edge of the blanket and slide it back until the front of the
blanket is flush to the front of bricks #21-24
(Figure 7).
Shake the blanket gently from side to side to get it to lay
flat. Be sure the ceramic blanket is directly on top of the
baffle bricks and that it does not hang out past the front
of the baffle as shown in Figure 7, also see note on Page
11.
19 C
20 H
21 F 22 A
23 F
24 F
Stainless
Steel Baffle
Supports
17D
18B
5
F
10
F
9
F
8
A
4
F
6
D
1
F
2
F
3
D
7
F
11F
12A
13F
14F
15G
16E
Figure 8