Filter
Top Products
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
18
E
F
(Valve Access Side)
(Valve Access Side)
Position The Round End Of Log (E) Against The Notch Of
Log (D) Here. Two Charred Spots Face The Front
D
Position Small End of Log
(E) on The Notch of Log
(C) Here
C
Log (F) Sits in
Front of The Grate
Figure 31
10. Place Log (E) as shown in Figure 31.
11. Place Log (F) as shown in Figure 32.
Figure 32
Step 9. INSTALLING/REMOVING GLASS ENCLOSURE PANELS
Lower Compartment
Door & Hinge
Glass Door (Enclo-
sure Panel)
Top Flange
Glass Door
Figure 33
Firebox Floor
Glass Door Latch
Bottom Vee-flange
Glass Door
Only doors certified with the appliance shall be used.
Seules des portes certifiées pour cet appareil doivent être
utilisées.
CAUTION: DO NOT abuse glass door by striking or slamming
shut.
1. Visually inspect the gasket on the backside of the panels. The gasket
surface must be clean, free of irregularities and seated firmly.
2. Position the glass enclosure panel in front of the firebox opening at
a 45 degree angle and engage the top flange over the lip at the top of
the firebox opening. See Figure 33.
3. Swing the glass enclosure panel down and back. Ensure the gasket
seats evenly as the panel draws shut. Engage the Vee-flange at the
bottom of the panel with the latches and close the latches to secure
the panel.
4. Reinstall the bottom control compartment access panel (if necessary) by
inserting the right side locating pin into the right side cabinet panel and
then the left side spring-loaded pin into the left side cabinet panel.
Glass Enclosure Panel Removal Instructions (see Figure 33) - Locate
the two (2) latches at the top of the control compartment. Open the two
latches from the bottom vee-flange of the glass enclosure panel (reach for
the handles located towards the back of the latches and pull the handles
down toward the front of the appliance).
WARNING
• Do not attempt to substitute the materials used on
these doors, or replace cracked or broken glass.
• Handle this glass with extreme care! Glass is
susceptible to damage – Do not scratch or handle
roughly while reinstalling the glass door frame.
• The glass door(s) of this appliance must only be
replaced as a complete unit as provided by the
manufacturer. Do not attempt to replace broken,
cracked or chipped glass separately.
• Do not attempt to touch the front enclosure glass
with your hands while the fireplace is in use.
WARNING
Do not operate appliance with the glass front
removed, cracked or broken.
AVERTISSEMENT
Ne pas utiliser l'appareil si le panneau frontal en
verre n'est pas en place, est craqué ou brisé.