Lennox Hearth LSM40ST-N-PV Indoor Fireplace User Manual


 
20
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
LENNOX HEARTH PRODUCTS • MONTEBELLO
®
SEE-THROUGH POWER VENT DV GAS FIREPLACES (LSM40ST-N-PV) • CARE AND OPERATION INSTRUCTIONS
A. This appliance is equipped with an ignition device which
automatically lights the pilot. Do not try to light the pilot
by hand.
B. BEFORE OPERATING smell all around the appliance area
for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electrical switch; do not use any phone
in your building.
Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
FOR YOUR SAFETY READ BEFORE OPERATING
If you cannot reach your gas supplier, call the re depart-
ment.
C. If any portion of this appliance does not operate as the
instructions indicate, do not try to repair it, call a qualified
service technician. Do not use tools. Force or attempted
repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system and any gas control which has been under
water.
OPERATING INSTRUCTIONS
1. Turn off all electric power to the appliance if service is to
be performed.
TO TURN OFF GAS TO APPLIANCE
OPERATING INSTRUCTIONS
WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY
RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
Remote
Off
On
PRG
Remote
Control
Transmitter
Receiver
1. STOP! Read the safety information above on this page.
2. Turn OFF all electric power to the appliance.
3. Read this manual including the section on "Remote Con-
trol System."
4. Slide the switch on the receiver to OFF.
5. Press ON/OFF button on transmitter to OFF.
6. This appliance is equipped with an ignition device which
automatically lights the pilot. Do not try to light the pilot
by hand.
7. Wait five (5) minutes to clear out any gas. If you smell
gas, STOP! Follow “B” in the safety information above on
this page. If you do not smell gas, go to the next step.
8. Turn on all electric power to the appliance.
9. Slide the switch on the receiver to REMOTE.
10. Press ON/OFF button on transmitter to ON.
11. If the appliance will not operate, follow the instructions
"To Turn Off Gas To Appliance" and call your service tech-
nician or gas supplier.
2. Slide the switch on the receiver to OFF.
3. Press ON/OFF button on the transmitter to OFF.
Hot Fireplace Will Cause
Severe Burns
Never Allow Children to
Touch Glass or other Fire-
place Parts
WARNING
Blue LCD Display
ON/OFF Key
ROOM
TEMPERATURE
Key
UP/DOWN
Arrow Key
MODE Key