Filter
Top Products
13
LENNOX HEARTH PRODUCTS • MONTEBELLO
®
SEE-THROUGH POWER VENT DV GAS FIREPLACES (LSM40ST-N-PV) • CARE AND OPERATION INSTRUCTIONS
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Separate glowing ember material
into THIN, square, dime-sized pieces.
Figure 10: Preparation of Glowing Ember Material
Bag of Glowing Embers
C
A
B
Figure 11: Placement of Glowing Ember Pieces
Control Side
Figure 12: Placement of Glowing Embers
Place
embers
in circled
areas.
PLACEMENT OF VOLCANIC STONE, GLOWING EMBERS,
AND LOGS
1. Remove glass door and mesh pull screens from one side of fireplace
only (see Page 12).
2. Locate materials (log set, bag of glowing embers, and bags of volca-
nic stone).
Note: LOGS ARE FRAGILE! Handle with care to prevent
breakage.
3. Install volcanic stone. Place some of the volcanic stone on the firebox
floor around the grate (the entire bag of volcanic stone will NOT be
used).
Note: Do NOT place volcanic stone on burner.
4. Prepare and install glowing embers.
Note: This appliance is provided with enough glowing
ember material for several applications. Do NOT use the
entire contents of a new bag at one time.
a) Separate some of the glowing ember material into pieces about
the size and thickness of a dime (see Figure 10). Keep the
pieces fluffed up, not matted.
IMPORTANT! Ember pieces must be
as SMALL and THIN as a dime.
b) Distribute the dime-sized pieces over the surface of the burner, in
the areas shown in Figures 11 and 12.
Note: To prevent flame impingement and soot, do not use
more ember material than necessary.
c) For best glowing effect, replace ember material annually.
Note: Use only catalog number H8312 Glowing Embers with
this fireplace.
Control Side
(top view of burner shown)
• Place glowing ember material in circled areas ONLY.
• Do NOT place glowing ember material over main flame gas ports.
• To prevent flame impingement and soot, do not use more ember
material than necessary.
WARNING
• DO NOT attempt to install the logs until the appli-
ance installation has been completed, the gas line
connected and tested for leaks, and the initial burner
operation has been checked out.
•
Logs get very hot and will remain hot up to one hour
after gas supply is turned off. Handle only when
logs are cool. Turn off all electricity to the appliance
before you install volcanic stone, embers and logs.
•
The size and position of the log set was engineered
to give the appliance a safe, reliable and attractive
flame pattern. Any attempt to use a different log
set in the fireplace will void the warranty and will
result in incomplete combustion, sooting, and poor
flame quality.
•
This appliance is not designed to burn wood. Any
attempt to do so could cause irreparable damage to
the appliance and prove hazardous to your safety.
•
If logs are not installed according to the log installa-
tion instructions, flame impingement and improper
combustion could occur and result in soot and/or
excessive production of carbon monoxide (CO), a
colorless, odorless, toxic gas.