Filter
Top Products
10 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE
15.0 SPARK GAP
The gap between the spark electrode and the pilot should be 1/8” to
3/16” to produce a good spark. There should be no need to adjust
this. If under any circumstances the piezo electric spark fails, the pilot
cannot be lit manually.
16.0 ASSEMBLY OF THE GLASS FACIA
Figure 9 - Proper Spark Gap
1/8" to 3/16" Spark Gap
Figure 10 - Key Hole Slots on Glass Facia
1. Remove the glass panel from all packaging and lay face down on a soft
surface. Identify the top and bottom of the glass facia by observing
the orientation of the keyhole shaped slots in the facia fixing brackets
as shown in Figure 10.
2. Slide on the side pieces ensuring that the grill fixing holes (shown) are
aligned towards the top of the glass facia (as shown in Figure 11).
Grill fixing holes
Figure 11 - Slide on Side Pieces
3. Ensure the sides are neatly aligned with the glass and secure the sides
using two M6 screws for each side as shown in Figure 12. Do not
overtighten the screws.
4. Position th
e grill within the two side pieces ensuring a proper fit.
Figure 12 - Secure Side Pieces
Figure 13
TOP
TOP
Side Piece