Filter
Top Products
11
5. Secure the grill in position using two M6 screws and two no. 8 self
tapping screws as shown in Figure 14.
17.0 FITTING THE GLASS FACIA
The glass facia panel is supported by four M6 screws which protrude
from the front of the outer casing. Insert the M6 retaining screws and
ensure they are unscrewed approximately 1/8” so the keyhole shaped
holes may engage, and the facia can be hooked on. Ensuring that the
corresponding keyhole shaped holes engage the screwheads fully. Refer
to Figure 15.
Figure 15
18.0 FITTING THE SIDE PANELS
Remove the two side panel assemblies from the protective packaging
and fit onto the sides of the firebox as shown. Insert the M6 retain-
ing screws in the sides of the firebox and ensure they are unscrewed
approximately 1/8” so the keyhole shaped holes may engage, and the
sides can be hooked on.
Note : Front frame/facia
not shown for clarity.
Figure 17
Insert a screwdriver through the holes in the right hand side panel to
access the two M6 fixing screws (designated ‘a’ in Figure 17) and tighten
fully. Next insert two no.8 self-tapping screws (designated ‘b’ in Figure
17) through the side panel support bracket, and the corresponding holes
in the side of the firebox. Tighten fully. Repeat for the left hand side panel,
which is secured by tightening the M6 ‘a’ screws only. The right-hand
side panel has a hinged flap to allow access to the control knob.
Figure 14 - Secure Grill In Position
Figure 16
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE
‘a’
‘a’
‘b’
‘b’