Filter
Top Products
6
Note: Some locations (Arizona and parts of Indiana) do not follow Daylight Saving Time, and should select
“DST OFF”.
6. Press and release the SET button to confirm and advance to the radio-controlled time on/off setting.
V. RADIO-CONTROLLED TIME ON/OFF SETTING
1. Press and hold the SET button for 3 seconds.
2. “LCD” will show in the TIME LCD and the number setting will flash.
3. Press and release the SET button three times.
4. “RCC” will appear in the DATE LCD and “ON” or “OFF” will flash in the TIME LCD.
5. Press and release the ALM/+ button to select radio-controlled time on or off.
6. Press and release the SET button to confirm and advance to the 12/24-hour time setting.
VI. 12 OR 24 HOUR TIME SETTING
1. Press and hold the SET button for 3 seconds.
2. “LCD” will show in the TIME LCD and the number setting will flash.
3. Press and release the SET button four times.
4. “12h” or “24h” will flash in the DATE LCD.
5. Press and release the ALM/+ button to select 12 or 24-hour time format.
Note: When in the 12-hour format “P.M.” will appear to the left of the hour in the time LCD between the hours
of noon and midnight.
6. Press and release the SET button to confirm and advance to the time setting.
VII. TIME SETTING
There are two methods by which the time and date can be set:
A) Automatically via WWVB reception, or
B) Manually.
A. WWVB (Remote Control Time)
This method requires you to do nothing, except wait for the signal to be received, and to select a time zone.
Reception usually takes approximately 10 minutes during optimal conditions. The best conditions for reception is at
night, between midnight and 6:00 am—when there is less atmospheric interference. To keep your time as accurate as
possible, the indoor weather station conducts a WWVB search every night between these hours, and overrides any
manually set time. The WWVB tower icon (appearing in the TIME LCD) will flash when a signal-search is in
progress and a signal is being received, and will remain steady when the signal has been received. If the WWVB
time has not been received after 15 minutes of battery installation, you may manually set the time or leave the time
function alone (reception will occur regardless).
B. MANUAL TIME SETTING
Note: When in the 12-hour format “P.M.” will appear to the left of the hour in the time LCD between the hours
of noon and midnight.
Note: Reception of the WWVB signal will automatically set the time. The reception of the signal will override
any programmed time.
1. Press and hold the SET button for 3 seconds.
2. “LCD” will show in the TIME LCD and the number setting will flash.
3. Press and release the SET button five times.
4. The hours digits will flash in the TIME LCD.
5. Press and release the ALM/+ button to advance the hours.
6. Press and release the SET button to confirm the hours setting and advance to the minutes setting.
7. The minutes digits will flash in the TIME LCD.
8. Press and release the ALM/+ button to advance the minutes.
9.
Press and release the SET button to confirm and advance to the year setting.