Filter
Top Products
20
2. Outdoor Minimum and Maximum Temperature and Humidity
The indoor weather station automatically stores the minimum and
maximum outdoor temperature and humidity. The minimum and
maximum values are updated automatically when a new minimum
or maximum is recorded, or until manually reset.
a. The outdoor (remote) minimum and maximum temperature
values are displayed below the outdoor temperature display.
b. These values are rounded down for minimum and rounded up
for maximum.
Note:
The temperature alarm mode shares the same display.
When the alarm values are displayed, “ALARM” will be displayed
above the remote temperature. To switch back and forth between
views, press the “OUT” key.
c. To reset the outdoor minimum and maximum temperatures
press and hold the “CH” key for at least one second.
D. Multiple Remote Temperature Sensors
The WS-8015U is able to receive signals from 3 different remote
sensors. These extra remote sensors can be purchased through the same
dealer as this unit. A TX4U will monitor the temperature and humidity,
a TX3U will monitor temperature and display the temperature on its
LCD and the TX3UP will monitor the temperature via a probe for
measuring soil or water temperatures.
Note:
When setting up multiple units it is important to insert batteries
first into all the remote sensors, and in numeric sequence. Second
install batteries into the indoor weather station. Transmission
problems will arise if this is not done correctly and if the total time for
set-up exceeds 6 minutes
1. Set Up of Multiple Units
a. It is necessary to remove the batteries from all units currently
in operation.
b. Remove the battery covers to all remote sensors.
c. Place all remote sensors in a numeric sequential order.
d. In sequential order, install batteries following the same battery
installation procedures seen in Detailed Set-Up Guide section
of this manual.
e. Install batteries into the indoor weather station.