dendum
1.
2.
3.
4.
5.
6.
7.
Programming a wireless remote using the KHS6S Wall Controller
Remove the Decora cover plate, and controller face plate.
Place your wireless remote in learn mode. (learn LED should begin flashing on the
KHSLRC model learning remote control)
Select the device bank button to program (i.e. TV, VCR, Tuner, Aux, etc.) on the
wireless remote.
Select the button to be programmed on the learning remote. (i.e. l-6, mute, or volume
up and down)
.While
holding the wireless remote within 2” from the top, center, clear LED on the
KHS6S (this is the controller IR emitter), press the command button on the KHS6S
Controller you wish to program into the wireless remote.
The wireless remote should then accept the KHS6S command. (the green “OK” LED
will then light on the KHSLRC model learning remote)
Once you have programmed the source device, volume up and down, and mute
functions for the first source device, you can then repeat steps 4-6 for the remaining
five source devices, until you have programmed all six sources for the KHS6640
amplifier.
*Please note when programming it is best to hold the KHS6S button until the wireless
remote has indicated that it has learned the command.
SMARTHOME.COM™
1-800-SMART-HOME
949-221-9200
http://www.smarthome.com
Order #8270C