Filter
Top Products
MACRO PROGRAMMING
The KHS-6D has 16 programmable macro memories. It will automatically transmit a series of 20
commands deep.
To enter the macro mode
-
press macro and the either the 0 through 9 buttons OR the device source
keys (l-6). You can insert a delay time from 1 to 99 seconds between steps (the default is
5
sec.) to
suit their specialized needs. To program in time delays, press the appropriate button and hold it from
1 to 99 seconds then input the next command.
Here is an example of how to set a macro.
The list of things you want to accomplish are:
1.) Power on receiver
2.) Set receiver input to Aux In
3.) Power on LaserDisc device
4.) Open LaserDisc Drawer
5.) Close drapes
6.) Dim lights
7.) Select Play on LaserDisc
Press Learn then Macro button to enter the Macro learning mode. The Red LED blinks and you should
input either 0 to 9 or device button (l-6).
1.) Press source button that is programmed to receiver
2.) Press Power Button to power up receiver
3.) Press Aux In on Receiver
4.) Select LaserDisc
5.) Power on LaserDisc device
6.) Open LaserDisc Drawer
7.) Close drapes (assuming drapes are under IR control)
8.) Dim lights (assuming the lights are also under
IR
control)
9.) Select Play on LaserDisc
Press the learn button or wait 15 seconds for it to return to normal. The red LED turns off.
\
I
To utilize the Macro Mode- press the macro button (it will only wait for 2 seconds for a second button
to be pressed) then press either numeric button (O-9) or source button (l-6) to engage a pre-programmed
macro.
To clear a macro out of memory, press clear then macro and then the key with the memory you wish
to erase. It is a permanent erase, so make sure you are careful. If no key is pressed within 15 seconds,
the unit will exit the clear mode and return to normal operation.
Page 14
SMARTHOME.COM™ 1-800-SMART-HOME 949-221-9200 http://www.smarthome.com Order #8270C