Filter
Top Products
6
7. Threading
ƽ
Warning!:
Before threading, make sure that the
sewing machine is switched off, or
that the power plug has been pulled
out of the power socket, as accidents
may be caused if the machine is started
unintentionally.
a) Threading the lower bobbin
To fill the lower bobbin with thread:
ᕦ Pull out one of the two roll pins and
put on a spool of thread.
Ẫ You can put a felt pad under the
spool of thread, to protect the
machine casing.
ᕧ Place an empty bobbin on the
winder spindle and wind the loose
end of the thread on, giving several
turns anticlockwise.
ᕨ Pull out the handwheel slightly, to
disengage the sewing mechanism
from the motor.
ᕩ Pull the thread through the thread
guide for the winder tension.
µ After the first few turns of thread are
taut on the bobbin, press the bobbin
against the winder stopper.
• Now switch on the sewing machine
and step on the foot switch. When
the bobbin is full, cut the thread.
ᕧ Press the winder spindle forward
again and take out the full bobbin.
ᕨ Do not forget to press the handwheel
back in, otherwise the sewing mech-
anism remains disengaged from the
motor.
²
¾
ᕨ
¶
µ
IB_Sewingmachine_content_UK.qxd 22.07.2004 12:21 Uhr Seite 6