Filter
Top Products
- 4 -
HOW TO REPAIR THE RIALTO, SAN RAPHAEL,
CABERNET, AND PILLOW TALK FLOAT AND
FLUSH VALVE.
INTRODUCTION
The following instructions are used to replace the plunger
assembly on the flush valve for the San Raphael, Rialto,
Cabernet, and Pillow Talk toilets. Refer to Fig.
#11.
Fig. #11
Float Valve Assembly
Screws
Cap Top
Cap
O-ring
Plunger Ass'y
Float Ball
Float Rod
Rim Tube
Supply Hardware
Gasket
Nut
Rim Diverter
Float
1. Loosen the screws and remove the cap top and cap.
2. Replace the OĆring and plunger assembly.
3. Place the cap and cap top back on valve. Tighten with
screws.
REPLACING THE TWIST-LOCK FLUSH VALVE
1. Refer to Fig. #12. Turn valve counterclockwise and reĆ
move.
2. To install new valve, apply a bead of silicone to the base
of the gasket. Insert into hole inside tank. Press down
and turn clockwise until valve is in proper position.
Twist Lock Flush Valve
Fig. #12
Flush Ball
Trip Chain
Flapper Hooks
Gasket
REPLACING THE OLD STYLE FLUSH VALVE
(RIALTO AND SAN RAPHAEL ONLY)
1. Refer to Fig. #13. Loosen three screws and turn
mounting hooks inward. Remove flush valve.
2. Assemble gasket to new flush valve. Position new flush
valve with three screws and mounting hooks into hole
in tank. Make sure mounting hooks are turned inward.
Turn mounting hooks outward and tighten screws.
NOTE: TOILETS WITH OLD STYLE FLUSH VALVES CAN
NOT BE FITTED WITH THE NEW TWISTĆLOCK VALVE.
STARTĆUP AND OPERATION FOR ROCHELLE
& PALARRE TOILETS
The trip lever assembly actuates the rotor and flush ball to
begin flush.
The float valve assembly controls the flow of water through
the rotor to the rim holes and tank. The adjusting screw