Filter
Top Products
Adjust High Flame Setting Screw
When converting from LP to Natural gas, you will need to
adjust the high flame setting screw for ideal burner flame
height.
1.Remove each control knob for the main burners and side
burner.
Record Conversion
1.The appliance nameplate is located inside the grill cabinet
on the left-hand cabinet side or inside of the cabinet door.
With a permanent marker, check the box next to ‘’Natural
gas’’ and mark through ‘’LP -Propane.’’ In the last page of
the Use and Care Guide, write ‘’Converted to Natural
Gas.’’ Also record the conversion date and the
technician/company that performed the conversion.
NOTE: Place LP gas parts in plastic parts bag for future use
and keep with pack containing literature.
5.Reinstall the searing side burner. Make sure that the igniter
is out of the way to allow proper positioning of burner. Use
Phillips screwdriver to attach the mounting screws.
6.Use Phillips screwdriver to reattach the igniter and searing
side burner plate.
7.
Reinstall searing side burner
cover (if removed).
Use
IMPORTANT: Check that the orifice is properly installed
inside of valve.
2.Use a flat-blade screwdriver to turn the high flame setscrew
counterclockwise approximate 90 degree.
3.Check that burner operates at the new high flame setting. It
may be necessary to adjust the screw setting slightly more to
get the ideal burner flame height.
7.
Reinstall searing side burner
cover (if removed).
Use
Phillips screwdriver to attach mounting screws.
8.Open the manual shutoff valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
9.Test all connections using an approved noncorrosive leak-
detection solution. Bubbles will show a leak. Correct any
leak found.
8